Filter Grids and Installation

Presented by Cayce Carr

Cayce Carr, Engineering Manager at RTT Finishing Solutions, covers exhaust filter grid sizes, part numbers, installation and proper use. He also shows how to install an RP W Series 5100 filter for maximum loading capacity and a positive seal. In this video: • Standard EXF grid and RP snap-in grids (20″ x 25″ and 20″ x 20″) • Snap-in grid installation and multi-stage use • EXF grid prong orientation • RP W Series filter orientation: seams, paper side and louvers • Installing the filter and checking for bypass

Video Chapters

Hello everyone. I’m Cayce Carr, Product Specialist for RP Filtration at RTT Finishing Solutions. Today we’re covering exhaust filter grids: sizes, part numbers, installation and proper use.

Filter grids

Our standard filter grid is the 20" x 20" EXF grid.

Our other filter grids are the RP snap-in grids, available in two sizes:

  • 20" x 25", part number 1011
  • 20" x 20", part number 1012

Installing RP snap-in grids

Installation is simple. Make sure the prongs with rubber fittings are in place on the top and bottom of the filter frame. That’s all it takes.

Use RP snap-in grids when you’re running multiple filtration stages. You’ll see why when we install the EXF grid.

Installing the EXF grid

When installing the standard EXF grid, position the four prongs to the left and right, and the three prongs facing outward on the top and bottom. This holds the filter properly.

Start with one side, then do the other. Again, keep the three prongs on the top and bottom facing outward. The two center side prongs sit behind the filter frame, and the top and bottom prongs sit on the front side of the frame.

Installing the filter

Today we’re installing an RP W Series 5100 filter, which comes standard with our spray booths. Install it in the correct orientation for the best efficiency and longest filter life.

On the back side, keep the sewn seams on a vertical plane, with the paper side facing outward. The louvers should open vertically, from top to bottom. As you spray and the filter captures particulate, each paper stage opens its pockets, which improves loading capacity.

The filter is slightly larger than 20" x 20", so you get a positive seal. When installing it, go slightly above the frame and keep it centered.

  1. Press in the two outside prongs on the top.
  2. With the filter centered, push in the center top prong.
  3. On the bottom, stretch the filter slightly so air passes through it properly and it loads evenly.
  4. Keep it centered and push in the center bottom prong.
  5. Press in the two outside bottom prongs.
  6. Secure the sides.

Once complete, check the entire perimeter for a positive seal, so no particulate bypasses into the exhaust chamber.

That’s it for exhaust filter grids. Thank you.


Additional Resources

Not Sure Which System You Need?

Get a system built around your application, with the right airflow, filtration, and fit for your facility.

Request A Quote

With over 75 years of combined experience engineering complex, multi-component finishing solutions, our team has the expertise to design and build equipment for projects of any scale — tailored precisely to your specifications.

 

Share a few details below and we’ll have a proposal back to you within 24 hours.