Quoting RTT Products: What To Do First
Video Chapters
- 0:00 Introduction
- 0:19 Liquid or powder coating
- 0:27 Your coating process
- 0:34 Largest part size
- 0:43 Curing: oven or heated booth
- 1:10 Equipment location
- 1:26 Fuel source
- 1:35 Nearby operations and contamination
- 1:43 Getting your quote
Video Transcript
Hi, I’m Alan Mustard, Regional Sales Manager for the Northeast US and Eastern Canada at Clean Air and RTT.
Today I’ll share a few tips on how to prepare for your project and what information we need to get you an accurate quote.
Coating type. Are you applying a liquid or powder coating?
Process. Walk us through your general process so we can configure the equipment to fit it.
Largest part. What’s the biggest part you plan to coat? This lets us size the equipment correctly and make it easy to move parts in and out of the booth.
Curing. Do your coatings have special cure requirements that call for an oven, or do we just need to heat the booth?
Location. Where will the equipment sit in your building and in your process flow? We want it in the right spot.
Fuel source. Will you use natural gas, propane or electricity to heat and cure?
Surroundings. What else is happening near the booth? Knowing this helps us protect your finish from dirt and contamination.
Once we have these details, reach out and we’ll put your quote together. We look forward to working with you.
Additional Resources
Spray Booth Recipe Setup
Presented by Bryan Willis
Spray Booth Sizing and Selection
Presented by John Owed
Proper Use and Measurement of a Manometer
Presented by Cayce Carr and Trey Peavy
Spray Booth Inspection for Compliance
Presented by John Owed
Monitor Part Temperature with Smartbatch
Presented by Bryan Willis
Download Reports from SmartTouch Control Panels
Presented by Bryan Willis
Not Sure Which System You Need?
Get a system built around your application, with the right airflow, filtration, and fit for your facility.
