FilterLoc and Filter Installation
Video Chapters
- 0:00 Introduction
- 0:12 FilterLoc Track system overview
- 0:20 Cutting and installation
- 0:44 Coverage and sizing
- 1:01 Converting pad filters to blanket media
- 1:29 Benefit 1: 60% labor savings
- 1:46 Benefit 2: eliminating filter bypass
- 2:34 Multi-stage filtration options
- 2:58 Installation and wrap-up
Video Transcript
Hello everyone. I’m Trey Peavy, Product Manager for RP Filtration Products at RTT Finishing Solutions. In this video, I want to highlight our FilterLoc Track system.
The track comes in a standard 40" length and can be cut to any length in the field. It’s made of PVC, so a Sawzall, hacksaw or tin snips will cut it to size. It attaches to the booth or filter rack with self-drilling, self-tapping screws and can be installed on virtually any surface.
In the cell behind me in our training facility, one 40" track covers two 20" x 20" filter grids. For this cell, two tracks give us the full width required.
This matters most for conversions. If your booth uses 20" x 20", 20" x 25" or other custom pad filters, and there’s a mounting surface around the perimeter of the filter face, we can convert it to blanket media with the FilterLoc Track system.
There are two main reasons to convert to blanket media:
1. Faster installation. A blanket installs faster than pad filters. You save about 60% in labor costs.
2. Better efficiency. We aren’t changing the filter type, but we are changing how it seals. A 20" x 20" pad has 20" of potential bypass on each side. If pads aren’t installed properly and seated correctly, that’s up to 80 linear inches of bypass per pad.
The FilterLoc Track system encapsulates 100% of the blanket’s perimeter. All the air that enters the exhaust chamber, exhaust fan and exhaust stack has to pass through the filtration system first.
The FilterLoc Track system can also be the first stage of a multi-stage system. Behind it, you can install a cube or bag filter with a panel using one of our RP snap-in grids. Run the FilterLoc Track system over the top for three-stage filtration.
The FilterLoc Track system is versatile and easy to install, and it can be done in minutes. For step-by-step instructions, check out our installation video.
Thanks, and have a great day.
Additional Resources
Air Make Up Unit Overview
Presented by Luke Downing
Quoting RTT Products: What To Do First
Presented by Allan Mustard
Understanding Static Pressure in Your Spray Booth
Presented by Trey Peavy
Not Sure Which System You Need?
Get a system built around your application, with the right airflow, filtration, and fit for your facility.
