Spray Booth Recipe Setup

Presented by Bryan Willis

Bryan Willis, Controls Manager at RTT Finishing Solutions, walks through programming a cure recipe on the CT Series AMU control panel. He covers spray, flash, cure and cool set points, saving your changes, and making the recipe active, so your booth runs the right cycle every time the operator presses Cure.

Video Chapters

In this video, we’ll show you how to set up a recipe on your CT Series spray booth air makeup unit (AMU).

Logging in

  1. Press the Target button.
  2. Log in with passcode 2050.

Selecting Set mode

Once you’re logged in, you’ll see an icon at the top right. Press the up or down arrows to change it. Select Set, which lets you view and adjust set points, then press Enter.

The first page shows the Active Settings: the recipe currently in use, in this case Recipe D, along with its temperatures and times.

Selecting a recipe

To make changes, go down one page to Recipe Set Points (1 of 2) and press Enter. The current recipe, Recipe D, is selected. To adjust Recipe B, select Recipe B and press Enter.

Setting spray, flash and cure 1

Your flash and cure settings should come from your paint’s spec sheet. It will typically list the flash temperature and time, for example 95°F for 15–20 minutes, and the cure temperature and time.

For this example:

  1. Spray temperature: set to 75°F and press Enter.
  2. Flash time: set to 600 seconds (10 minutes) and press Enter.
  3. Cure 1 temperature: set to 150°F and press Enter.
  4. Cure 1 time: 12 minutes is short, so increase it to 45 minutes and press Enter.

Saving changes

This step is important. Set Save Changes to Yes and press Enter. If you don’t, everything you just entered will be erased.

Setting cure 2 and cool

“1 of 2” means there’s a second page of settings. Go down to the next page. It still shows Recipe B, with the cure 2 and cool settings.

  1. Cure 2: use this if you need to raise or lower the temperature after cure 1. Many people don’t use it. If you don’t, set its time to 0.
  2. Cool temperature: for example, return to the spray temperature of 75°F. Press Enter.
  3. Cool time: for example, 300 seconds (5 minutes). Set this however you like.
  4. Set Save Changes to Yes and press Enter.

Activating the recipe

Go back up to Active Settings to check your work. It still shows Recipe D, so these aren’t the values you just entered. To make Recipe B active:

  1. Press Enter.
  2. Select Recipe B.

The active settings now show 75°F, 600 seconds, 45 minutes and 300 seconds. That’s the recipe that runs when you press the Cure button.

Total cure time

Back out to the home screen. The total cure countdown shows 60 minutes, the sum of all the recipe times. When the operator leaves the booth and presses Cure, the cure cycle runs for 60 minutes.

Thanks for watching.


Additional Resources

Not Sure Which System You Need?

Get a system built around your application, with the right airflow, filtration, and fit for your facility.

Request A Quote

With over 75 years of combined experience engineering complex, multi-component finishing solutions, our team has the expertise to design and build equipment for projects of any scale — tailored precisely to your specifications.

 

Share a few details below and we’ll have a proposal back to you within 24 hours.